- Clean and reseat the printhead (Deprime system first)
- Reboot Duraflex system
Priming and Depriming Issues
- If an error is preventing you from depriming the system, call the support staff at (770) 427-4203
- If your system is not priming all color channels, deprime the system and remove the printhead for closer inspection of the ink channel ports and corresponding nipple o-rings. If it all looks good, reinstall the printhead and push down on the plastic plates that house the nipples to create a better seal and prime the system again.
Streaking and Scuffing
- Raise the printhead
- Double check leveling of printhead plate relative to the base belt using the included blocks.